Applicable to: '90 - '97 1.6 liter
Colored face plate and chrome bezel for the Heater/AC controls.
This is the coolest thing I have bought for my Miata in a long time! Installation is not difficult. Just remove the center console, remove the stereo/heater console, remove the sliders, and pull the fan control knob off. Next, the heater/AC plate pops off the unit. Finally,with a utility knife, carefully remove the factory plastic pieces from the plate which you have removed(be careful removing these pieces, as you will want to hang on to your original parts). The new colored pieces are stuck on the plate with double sided tape (I didn't use the tape, the pieces were held with the glue left from the original pieces. The new chrome bezel is placed on top of the original plate with double sided tape (I did use this tape because it is already on the bezel for you and you don't want the bezel sliding off). Put everything back and your done! If you want to see a picture of mine, go to: http://mypeoplepc.com/members/thebachestas/thebachestassite/
Good instructions, looks great! Moss has a variety of colors, I chose white to match my gauge faces, with green font to match factory look. Some font is blue and red to show hot and cold. This really is a nice looking product.
Under 30 minutes to remove completely
Applicable to: '99 +
Set of 4 stainless vent rings.
After researching this product for months via the Product Reviews Section I finally decided on these based on the price. Shipping from Moss was extremely fast and the item was packaged very well.
I'm very pleased with these, just enough "flash" but not over-stated. Installation was a breeze with the already applied adhesive. Fit and finish were excellent. Probably will order the hazard light ring next. Overall I would say this was an excellent product at a competitive price.
Not an installed item
| Back to Product Reviews | 22 November, 2003 |